This end feed capillary fitting joints copper tube manufactured to BS EN 1057 using solder. It's suitable for above ground hot and cold domestic or potable water services, central heating systems, low-pressure steam heating and pressurised unvented heating systems.
Part of the Made4Trade range and manufactured to BS EN 1254-1, this fitting is equally suitable for sanitation services and compressed air lines, gas distribution systems for natural and manufactured gases.
A solder joint is created through the principle of capillary action. When the fitting and tube is assembled and heated to the appropriate temperature, solder becomes molten and is drawn into the gap between tube and fitting for a durably reliable joint. It is recommended that soldering flux is also used to aid this.
• Manufactured from copper
• For use on hot and cold water systems
• Neat, tidy installation when installed by an experienced fitter
• WRAS-approved
• Manufactured to BS EN 1254-1
• Min temperature at max pressure: 30°C at 25 Bar
• Max temperature at max pressure: 110°C at 10 Bar
• 25-year manufacturer's guarantee
• Requires solder and blowtorch
• Available in a range of sizes from 8-28mm - see dropdown menu
• System covers all aspects of gas and heating systems in domestic and light commercial applications
Plumbing Solder and Flux
• Plumbing solder available -
11150• Plumbing flux available -
73706 &
21961Copper Pipes
• 15mm -
78209,
92917,
82026 &
64968• 22mm -
58030,
60997,
39919 &
59809• 28mm -
49958 &
43741